Våra exjobbare Jesper och Fredrik är klara med sitt exjobb, AI-assisterad spårning av flygande objekt och distansberäkning inom kastgrenar.
Med hjälp av kameror har de bland annat kunnat förutsäga hur lång en kulstöt kommer att bli. Ladda ner ex-jobbet här.
Flir Systems is using BitSim’s FPGA-IP, Bit-MIPI CSI-2 in their newly launched advanced thermal cameras. Read more.
The MIPI Alliance, the non-profit corporation that brings the mobile industry together, has standardized the interface between the camera/image sensor and the receiving electronics (host processor or similar) for further image processing, through a high-speed serial interface, the MIPI CSI-2.
The market for image sensors is increasing by over 10% annually, with the consumer and automotive markets leading this growth.
With MIPI CSI-2, the camera providers can reach the market faster with this standardized way of interacting with the sensors: at a faster speed, at a higher resolution, or more cost effectively.
Today, MIPI CSI-2 is also used in other areas, such as test and measurement, industrial or medical markets.
“BitSim has supported us in an exemplary way, and BitSim’s IP is one important part of the complete effort that made us reach the market faster in launching our new advanced thermal imaging cameras”, says Rikard Thunell, Vice President Sourcing & Strategic Planning of Flir.
1-4 data lanes
AXI4-Stream Video output
D-PHY protocol decoding included
Clock-lane/data-lanes deskew
Full High Speed/Low Power mode support
Test/debug features
Dataskyddspolicy
